---

Changing the fill order

---

If you've drawn multiple filled shapes in a Vector node, their fills may not be in the correct order: one fill may be appearing above another, where you require it to be beneath. You can change the order of a fill by selecting it (see Selecting fills), and then choosing the appropriate tool

There are two tools for raising fills:

• The Raise Fill tool raises the fill a single time, so that it is above the fill which it was previously beneath.

• The Topmost Fill tool raises the fill to the top, so it is above all other fills.

and two tools for lowering fills:

• The Lower Fill tool lowers the fill a single time, so that it is beneath the fill which it was previously above.

• The Bottom-most Fill tool lowers the fill to the bottom, so it is beneath all other fills.

Titan House, Castle Park, Cambridge CB3 0AY, England Tel: +44 (0) 1223 488200 Fax: +44 (0) 1223 488201 e-mail: support@cambridgeanimation.com

Animo NT User's Guide - Version 2.0 - 29 Jan 1999 Copyright © Cambridge Animation Systems